Central heating · Leeds
From a single cold radiator to a full new heating system, our engineers repair and install central heating across Leeds. We'll find the cause, explain your options and give you a clear price before we start.

Sludge builds up in older systems and causes cold spots, noisy boilers, slow heat-up times and breakdowns. Look out for radiators that are cold at the bottom, black water when you bleed a radiator, or a boiler that keeps cutting out.
A power flush followed by a magnetic filter can make a big difference to efficiency and comfort.
If you have no heating at all, or the boiler shows a fault code, see our boiler repair page or call us on 0113 532 7670.
A power flush cleans the sludge, rust and scale out of your radiators and pipes. We connect a pump to the system, run a cleaning chemical through each radiator in turn, then flush everything out with clean water. We finish by adding inhibitor to protect the system, and we can fit a magnetic filter to stop sludge building up again.
If your boiler is also due a service, our Gold boiler service, £200 + VAT (£240 inc. VAT), includes a chemical clean and a full system flush.
We fit new radiators, move or resize existing ones, and replace sticking or leaking valves. Thermostatic radiator valves (TRVs) let you set each room to the temperature you want, which saves gas in rooms you don't use much.
A modern thermostat or smart control can cut your bills and lets you control the heating from your phone. We fit and set up thermostats and smart heating controls to suit your boiler.
We're based on Broad Lane in Stanningley and work across the whole of Leeds, including Pudsey, Horsforth, Headingley, Bramley, Armley, Morley, Rothwell, Garforth, Roundhay, Kirkstall, Farsley, and Otley.



Every engineer is Gas Safe registered (986318) and carries their Gas Safe ID card.
Usually there's air in it, and bleeding the radiator normally fixes it. If it keeps happening, there may be a leak or a fault that needs an engineer.
That's usually sludge. A power flush or chemical clean will normally solve it.
Turn the heating off and let the radiator cool. Hold a cloth under the bleed valve at the top corner, open it a quarter turn with a radiator key until water appears, then close it. Check the boiler pressure afterwards and top it up if it has dropped below 1 bar.
If several radiators are cold at the bottom, or the water is black when you bleed them, the system has sludge in it. We'll look at the system and tell you which clean it needs.
Yes. We fit and repair vented and unvented hot water cylinders.
Tell us what you need and we'll get back to you within one working day. You can attach photos, which helps us quote faster.
Our engineers will find the cause and give you a clear price before any work starts.
